Dew Not Dual Heaters for Binoviewer – DN017 Dew Not

The Dew Not Binoview Heater System is the ultimate dew remover for your binoviewer’s optics. Using the same technology as the standard Dew-Not dew remover, the Binoview heater helps ensure the clearest nighttime viewing possible. Includes two 6″ wraps joined with a 4″ jumper. Even though each binoviewer eyepiece will be heated separately there is only one power supply cord. A power takeoff plug allows you to use one of the heaters elsewhere when not using your binoviewer.

Proudly made in the USA, the Dew-Not Dew Remover is a thick film heater manufactured for operation at 12 volts. Sixty-six percent of the surface area is heat emitting – this means more even heat distribution and no localized hot spots or burnouts often associated with resistance wire heaters. Protected by over 30 USA and international patents, and carrying more than 20 years of constant improvements and enhancements, the Dew-Not Dew Remover is the ultimate in reliability and efficiency.

Features

• Dual Dew Heater pads for binocular viewers.

• Cloth covered with foam insulation on outer side for maximum efficiency and performance.

• Dual 6″ eyepiece elements with velcro closure connected in tandem with 4″ cord.

• 6′ cord with molded RCA jack.

• Heater strip length: 6.0″ (15.2cm) each.

• 12 Volt

• 5.6 Watts

• 0.47 Amps

• Compatible with standard dew heater controllers.

Note: Image of the two dew heaters does not show the 4″ cord that connects them. You can see an example if you check out the image of the heaters installed on a binoviewer, which is, of course, sold separately.