Perfect for observing during the winter or in cold climates, this Dew-Not Heater is sized to hug the back of standard hand-held telescope controllers and keep them warm and dry. The controller heater has a dual rubberband that allows you to attach it to your controller while leaving the front side controls accessible. Plug the heater controller into a port on a dew controller such as the Dual Channel model from Dew-Not.
Proudly made in the USA, the Dew-Not Dew Remover is a thick film heater manufactured for operation at 12 volts. Sixty-six percent of the surface area is heat emitting – this means more even heat distribution and no localized hot spots or burnouts often associated with resistance wire heaters. Protected by over 30 USA and international patents, and carrying more than 20 years of constant improvements and enhancements, the Dew-Not Dew Remover is the ultimate in reliability and efficiency.
Features
- Dew Heater pad for handheld contollers.
- Cloth covered with foam insulation on outer side for maximum efficiancy and performance.
- Dual rubber band attachment to back of handheld controller.
- 6′ cord with molded RCA jack.
- Heater strip length: 4.5″ (11.4cm).
- 12 Volt
- 2.5 Watts
- 0.21 Amps
- Compatable with standard dew heater controllers.
Please Note: The heating element within the dew strip is 1″ shorter than the length of the entire strip.